Toshiba TOSVERT VF-nC3 Instruction Manual page 51

(3) Coast stop
The standard default is slowdown stop. To make a
coast stop, assign "6 (ST)" to an idle terminal.
Change to =.
For coast stop, open the ST-CC when stopping the
motor in the state described at left.The monitor on the
inverter at this time will display .
A coast stop can also be made by assigning "
(FRR)" to an idle terminal.
When doing this, a coast stop is done by FRR and CC
both turning on.
3.2.2
[Example of  setting procedure]: Setting the frequency setting destination to the terminal block
3
Panel operation
MODE
* Pressing the MODE key twice returns the display to standard monitor mode (displaying operation frequency).
(1) Setting using the keypad (= or )
Example of operating from the panel (=: press in center to save)
Panel operation
How to set the frequency
LED display
Displays the operation frequency (operation stopped).

(When standard monitor display selection = [Operation frequency])

Displays the first basic parameter [History ()].

Turn the setting dial, and select "".
Press the center of the setting dial to read the parameter value.

(Standard default: ).
Turn the setting dial to change the parameter value to  (terminal block

VI).
The parameter value is written. and the parameter value are
⇔
displayed alternately several times.
: Moves the frequency up
LED display


⇔
Motor
speed
F-CC
ST-CC
Operation
: Moves the frequency down
Displays the operation frequency.
(When standard monitor display selection = [Operation frequency])
Set the operation frequency. (The frequency will not be saved if the
power is turned off in this state.)
Save the operation frequency.  and the frequency are displayed
alternately.
C-6
E6581595
Coast stop
ON
OFF
ON
OFF
Operation