Toshiba TOSVERT VF-nC3 Instruction Manual page 114

Setting of switching terminals
To switch to motor 2, assign the following functions to a terminal not being used. It is also possible to switch
to acceleration/deceleration 2 (AD2). For details, see 6.15.1.
It is possible to set 3 functions for terminal F and R, and 2 functions for terminal S1 and S2.
Note 1: Each of the following numbers (25, 29, 33) are reverse signals.
Note 2: Switching from "V/F constant" to  =  to  cannot be done while running. Stop the moter before
Note 3: Integral value of motor electronic thermal is cleared, after the motor switching.
6
Example of setting a terminal for switching : Sink logic
Input terminal function number
24 28
AD2 VF2
OFF OFF
ON OFF
OFF ON
OFF OFF
changing.
F (F: Forward run)
CC
S1(AD2)
S2(VF2)
R(OCS2)
Parameters changed from applicable parameters and
32
default standards 
OCS2
Standard default:
OFF
 、
OFF
 V/F constant , 
OFF
  , 
 
ON
Forward run command
2nd acceleration/deceleration switch
2nd V/F setting switch
2nd stall prevention operation switch
F-10
E6581595
 ,  ,  ,  ,  ,  ,
 ,  , 
、
 ,   ,

