Heater Mechanism - Epson SC-S30600 Series Service Manual

SC-S30600 Series

3.4.7 Heater Mechanism

3.4.7.1 Pre Heater
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p200)
perform the specified operations including required adjustment.
In the next step, remove the screws while holding the Pre Heater
C A U T I O N
with your hand to prevent it from falling.
1. Remove the two screws that secure the Pre Heater, and hang the Pre Heater Assy
on the main body as shown in Figure
A) Silver M3x8 S-tite screw with built-in washer: 2 pcs
As the Pre Heater is put on the main body with the cables placed
C A U T I O N
between the assy and main body, be careful not to press the assy
and cause the cables getting damaged.
2. Disconnect the cables from the three relay connectors.
Pre Heater
A
Figure 3-131. Pre Heater Fixing Screws
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
3-132.
A
Disassembly and Assembly Procedure
Relay Connectors
Pre Heater
Figure 3-132. Removing the Pre Heater
Pre Heater
Figure 3-133. Pre Heater
Revision B
Hang the Assy
171
Confidential