Epson SC-S30600 Series Service Manual page 142

SC-S30600 Series
10. Remove the three screws that secure the Pump Cap Unit.
B) Silver M4x8 S-tite screw with built-in washer: 3 pcs
11. Remove the two Waste Ink Tubes from the joint, and release the tubes from the
clamp.
12. To prevent ink from dripping, insert the tip of the Waste Ink Tube into the hole
shown below.
13. Pull the Pump Cap Unit frontward to disengage the hook, and remove the Pump
Cap Unit avoiding contact with the CR shaft or any other parts.
B
Hook
B
Joint
Clamp
Waste Ink Tube
Figure 3-93. Removing the Pump Cap Unit
DISASSEMBLY & ASSEMBLY
Pump Cap Unit
B
Insert the tip of the tube
Disassembly and Assembly Procedure
Revision B
142
Confidential