Epson SC-S30600 Series Service Manual page 175

SC-S30600 Series
3.4.7.4 Cooling Fan
1. Remove the After Heater. (p174)
2. Remove the Sub-E Board Cover. (See
3. Disconnect the cable of the Cooling Fan from the connector (CN518) on the Sub-E
Board.
4. Release the cable of the Cooling Fan from the two clamps.
5. Insert the screwdriver through the holes on the frame at the Cooling Fan side to
remove the two screws that secure the Cooling Fan, and remove the Cooling Fan.
A) Silver M3x22 S-tite screw: 2 pcs
DISASSEMBLY & ASSEMBLY
Step 2 in "3.4.4.6 Sub-E Board" (P.
Disassembly and Assembly Procedure
115))
CN518
Sub-E Board
Figure 3-139. Removing the Cooling Fan
Revision B
- Right side -
Holes
Clamp
A
A
Cooling Fan
Confidential
175