Epson SC-S30600 Series Service Manual page 58

SC-S30600 Series
Symptom
After Heater power failure occurs
It takes a longer time to warm up the
heater.
The Drying Fan does not work when
printing.
TROUBLE SHOOTING
Table 2-4. Other Troubles
Cause
The power cable of the After Heater is
not connected.
1. Is the heater setting appropriate in the ambient
It takes 10 minutes or longer until the
heater temperature reaches the preset 2. Is the thermistor detached from the plate?
level.
See the panel display to identify which heater has not been
warmed up.
The power cable of the Drying Fan Unit
Does the Drying Fan icon appear on the panel display?
is not connected.
The Drying Fan Unit is not connected
Does the Drying Fan icon appear on the panel display?
to the printer.
The Drying Fan function has been Does the Drying Fan icon (ON) appear on the panel
disabled with the panel setting. display?
Check Item
---
temperature?
Other Troubles
Revision B
Remedy
Connect the power cable of the After Heater.
1. Make the following settings.

Raise the ambient temperature.

Turn the heater temperature setting down.
2. Screw the thermistor on the plate.
Connect the power cable of the Drying Fan Unit.
Connect the Drying Fan Unit to the printer.
Enable (select "ON") the Drying Fan function.
Confidential
58