Epson SC-S30600 Series Service Manual page 181

SC-S30600 Series
3.4.8.5 ATC Motor
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p200)
perform the specified operations including required adjustment.
1. Remove the Roll Paper Holder of the Right Roll Unit.
2. Remove the Right Roll Side Cover.
"3.4.8.4 Sub-F Board (Roll)"
(See Step 2 to Step 5 in
3. Disconnect the cable from the connector (CN606) on the Sub-F Board.
4. Release the cable from the clamp, and remove the Right Roll Cover.
5. Disconnect the cable from the connector of the ATC Motor.
ATC Motor Connector
Right Roll
Cover
CN606
Figure 3-146. Removing the Right Roll Cover
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p178)
(P. 179))
Clamp
Sub-F Board
Disassembly and Assembly Procedure
Perform the next step while holding the Compound Gear with your
C A U T I O N
hand to prevent it from falling.
6. Remove the three screws that secure the Right Roll Side Frame.
A) M3x8 S-tite screw: 3 pcs
7. Slide the Right Roll Side Frame in the direction of the arrow to remove it.
Right Roll Side Frame
A
ATC Motor
Figure 3-147. Removing the Right Roll Side Frame
Revision B
Compound Gear
A
A
Sub-F Board
181
Confidential