Epson SC-S30600 Series Service Manual page 191

SC-S30600 Series
3.4.9.5 Tension Bar Upper Sensor / Tension Bar Lower Sensor
1. Remove the screw, and remove the stopper.
A) Silver M4x12 screw: 1 pcs
2. Remove the three screws, and remove the Sensor Cover.
B) Silver M3x8 P-tite screw with built-in washer: 3 pcs
Route the cable through the hole on the Sensor Cover shown in the
figure below.
Cable
3. Disconnect the cable from the connector of the sensor.
4. Disengage the hooks, and remove the sensor.
DISASSEMBLY & ASSEMBLY
Sensor Cover
Hole
Disassembly and Assembly Procedure
A
Stopper
B
Figure 3-159. Removing the Sensor Cover
Connector
Connector
Figure 3-160. Removing the Tension Bar Upper Sensor
Revision B
Sensor Cover
- Right side -
B
B
Tension Bar Upper Sensor
Tension Bar Lower Sensor
191
Confidential