Epson SC-S30600 Series Service Manual page 45

SC-S30600 Series
Code Error Name
1F80 CSIC error CSIC control error
1F81 CSIC error CSIC control error
1F82 CSIC error CSIC control error
CSIC control error
1F83 CSIC error
1F84 CSIC error CSIC control error
1F85 CSIC error CSIC control error
CSIC control error
1FB9 CSIC error
1FC0 CSIC error CSIC control error
CSIC control error
1FC1 CSIC error
2000 NVRAM error NVRAM erase or write error has occurred.
Writing to the SDRAM was attempted, but nothing
2002 SDRAM error
could be written to it.

FLASH BOOT Installing the firmware has failed.
2003
checksum error 
The Flash ROM is out of order.
200A F/W load error Reading/decompressing the firmware has failed.
A system failure such as CPU failure, or defective
System interrupt
200D
watchdog time-out error cash has occurred.
The AC power has been shut off due to a power
3000 AC shut-off failure, unplugged, Power Supply Board failure, or
Main Board failure or the like.
This error is intended to be used in the product
Service call for FW development stage. It is supposed to not occur with
Dxxy
debugging marketed product, but may occur due to an
unexpected cause such as external noises.
TROUBLE SHOOTING
Cause
Is the Power cable properly connected?
Turn the power off and back on. Does the printer
recover from the error? (No repair work is needed
unless the error occurs again.)
Remedies for Service Call Error
Check Item
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
1. Replace the IC Holder.
---
2. Replace the Main Board.
--- Replace the Main Board.
--- Replace the Main Board.
1. Re-install the firmware.
---
1. Replace the Main Board.
1. Re-install the firmware.
---
1. Replace the Main Board.
--- Replace the Main Board.
1. Replace the Power Supply Board.
2. Replace the Main Board.
1. Re-install the firmware.
2. Replace the Main Board.
Revision B
Remedy
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 143)
(Page 107)
(Page 107)
(Page 107)
(Page 227)
(Page 107)
(Page 227)
(Page 107)
(Page 107)
(Page 109)
(Page 107)
(Page 227)
(Page 107)
45
Confidential