Menu Structure - ABB FV4000 Operating Instruction

8.6

Menu structure

Important
All parameters with a dark-gray background are part of the "Standard" menu level.
Buttons Menu item
Progr.
„C/CE"
Level
„Data" ProgProt
„Step" Code
„Data" Language
„Step"
„Data" Flowmeter
„Step" primary
„Data" Meter
„Step" size
„Data" Avg.
„Step" k-Factor
„Data" Diam.
„Step" Correct.
D184B097U02
Buttons Set parameter
„Enter" +
Blocked
„Enter"
„Enter" +
Change
Code
„Enter"
New
„Enter"
Code
„Enter" +
English_
„Enter"
„Enter" +
VORTEX
VT / VR_
„Enter"
„Enter"
D 15mm
0.5in
„Enter"
52000.0
1/m3
„Enter"
Sched.40
Configurable
Buttons Comments
parameters
„Step" Standard_ "Standard" menu:
Standard menu with all customer-specific menu
entries needed to operate the meter.
"Specialist" menu:
Specialist_
„Step"
Special menu with all customer-specific menu entries.
"Service" menu:
Service_
Additional display of the service menu following entry
„Step"
of the correct service code number "SRV code" (this
menu is only available to ABB Service).
Entry type: from table
„Enter" 0 If a number other than "0" (factory setting) has been
selected for the "P.protect. code", it will only be
possible to deactivate programming protection by
entering a number from 1 to 9999 as the "P.protect.
code".
„Enter" 9999
„Data" German_ Languages: German, English
„Step"
„Data" DDM To select the flowmeter sensor:
ST / SR_ VORTEX: FV4000-VT4/VR4
„Step"
DDM:
To display the nominal size of the flowmeter sensor:
A:
D:
To display the mean calibration:
k factor
Selection: Sched.40, Sched.80
This parameter only appears on flowmeter sensors
with ANSI process connection. Correction of the inner
diameter offset for connecting cables Sched. 40 or
Sched.80.
FV4000 / FS4000
Parameterization
FS4000-ST4/SR4
ANSI
DIN
69