Navigation And Data Entry - ABB FV4000 Operating Instruction

8.3

Navigation and data entry

8.3.1 Selecting parameters in a submenu
1. Deactivate programming protection (see page 67 ).
Important
If an attempt is made to modify a parameter when programming protection is active, "* Prog.
protect." will appear on the display.
2. Press the "C/CE" button once.
The display changes to menu mode.
3. Press the "Data" and "Step" buttons to select the required menu.
4. Then execute the "Enter" function (by pressing "Data" and "Step" at the same time).
The current parameter settings appear on the display.
5. Run the "Enter" function again.
6. Repeat steps 1 to 4.
An underscore appears after the current parameter settings.
7. Now press "Data" or "Step" to select the new parameter and apply your selection with the
"Enter" function.
8. Reactivate programming protection (see page 68 ).
8.3.2 Changing a parameter value
Where there are multiple parameters, a numerical value has to be entered. The "Data" and
"Step" buttons are also used to enter numbers.
If a parameter requiring a numerical entry is selected, a "0" will appear in the top left-hand
line and the corresponding unit will be shown in the line below.
1. Press "Data" to enter the numerical value.
Pressing this button repeatedly will show the numbers 1 to 0 consecutively, along with
special characters if these are required.
2. Once the correct numerical value has been set, press the "Step" button.
Another "0" appears in the next numerical location.
3. Repeat step 1 to set the correct numerical value here.
4. Keep repeating steps 2 and 3 until the entire numerical value has been entered.
5. Finally, run the "Enter" function again.
The numerical value of the parameter is applied.
8.3.3 Saving parameters
Important
Should the supply power fail, all device parameters and the meter reading will be backed up
safely in an FRAM. This means that the transmitter will be ready to resume operation
immediately when the power is restored.
D184B097U02 FV4000 / FS4000
Parameterization
65