ABB FV4000 Operating Instruction page 72

Parameterization
Buttons Menu item
„Data" Units
„Step" Temp
„Data" Reference
„Step" Temp
„Data" Pressure
„Step" Poper abs
„Data" Vol.Exp-
„Step" ansion
„Data" Density
„Step" extens.
„Data" Units
„Step" Qvol
„Data" Units
„Step" Qm
72
Buttons Set parameter
„Enter" +
°C_
„Enter"
„Enter"
20.0 °C
„Enter" +
1.0 bar
„Enter"
„Enter" +
1.00 %./K
„Enter"
„Enter" +
1.00 %./K
„Enter"
„Enter" +
l/s _
„Enter"
„Enter" +
g/s _
„Enter"
Configurable
Buttons Comments
parameters
„Enter" F_ Selection:
°C, F, K
Selection:
-200.0 ... 500
The menu appears when the following operating
modes are selected:
Fluid Qm (D), fluid Qm (D,T), gas standard Qn (Kmpf)
The menu appears when the following operating
mode is selected:
Gas mass Qm (pT)
The menu appears when the following operating
mode is selected:
Fluid Qm (V,T)
The menu appears when the following operating
mode is selected:
Fluid Qm (D,T)
„Step" l/m _ Selection:
l/s, l/m, l/h, m3/s, m3/m, m3/h, m3/d, ft3/s, ft3/m, ft3/h,
ft3/d, usgps, usgpm, usgph, usmgd, igps, igpm, igph,
igpd, bbl/s, bbl/m, bbl/h, bbl/d
The menu appears when the following operating
modes are selected:
Fluid Qm (D,T), fluid Qm (V,T), gas mass Qm (pT),
gas mass Qm (D)
„Step" g/m _ Selection:
g/s, g/m, g/h, kg/s, kg/m, kg/h, kg/d, t/m, t/h, t/d, lb/s,
lb/m, lb/h, lb/d
The menu appears when the following operating
modes are selected:
Fluid Qm (D), fluid Qm (D,T),
gas standard Qn (Kmpf), gas mass Qm (pT),
gas mass Qm (D)
FV4000 / FS4000
Important
The "Qvol" and "Qm" parameters are
dependent upon the selection made under
"Operating mode".
D184B097U02