Arctic Cat 1000 XT 2014 Service Manual page 88

2. Install the engine/transmission into the frame from
the right side.
3. Rotate the driveshaft 90°; then lift the front of the
engine sufficiently to engage the splined shaft into
the front differential. Lower the front of the engine.
4. Align the rear output drive flange and the rear yoke
flange and install the cap screws. Tighten to 20 ft-lb.
5. Align the engine with the mounting brackets and
install the through-bolts with flat washers; then
install the flange nuts and tighten to 45 ft-lb.
6. Connect the coolant hose and tighten the clamps
securely.
7. Secure the engine and harness grounds to the engine
and tighten the cap screw to 8 ft-lb.
86
GZ117A
8. Install the ignition coils and tighten the cap screws to
7 ft-lb; then connect the primary wires, grounds, and
spark plug caps.
9. Connect the stator coil connector and crankshaft
position sensor connector; then connect the gear
position switch connector.
GZ110A
GZ119
10. Install the front the rear exhaust pipes with new gra-
foil seals and tighten the retaining nuts to 20 ft-lb;
then install the muffler and connect all exhaust junc-
ture springs.
GZ064A
GZ069A
GZ493A