Arctic Cat 1000 XT 2014 Service Manual page 59

27. Place the C-rings into position in their grooves in the
cylinder heads.
28. Install the cylinder head plugs in the cylinder heads with
the open end facing downward and toward the inside.
CAUTION
The open end of the plug must be positioned downward.
29. Remove the cap screw from the end of the chain ten-
sioner; then using a flat-blade screwdriver, rotate the
adjuster screw inside the tensioner clockwise until the
screw bottoms.

NOTE: The adjuster shaft will be drawn into the ten-
sioner as the adjuster screw is rotated clockwise. The
adjuster shaft tension will be released in step 30.
30. Place the chain tensioner adjuster assembly and gasket
into position on the cylinder and secure with the two
cap screws.
31. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until the
CC012D
tensioner spring bears tension; then install the cap
screw into the end of the chain tensioner.
GZ162A
32. Loosen the four adjuster screw jam nuts; then loosen
the four adjuster screws on the rocker arms in the
valve cover.
CD501
CD469
GZ201
CD471
GZ199
57