Arctic Cat 1000 XT 2014 Service Manual page 15

2. Connect the new bulb assembly to the wiring harness
connector; then insert into the headlight housing and
rotate fully clockwise.
To replace the taillight-brakelight bulb, use the following
procedure.
1. Turn the bulb socket assembly counterclockwise and
remove from the housing.
2. Pull the bulb straight out of the socket; then insert a
new bulb.
3. Insert the bulb socket assembly into the housing and
turn it clockwise to secure.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light zone
is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).

NOTE: There should be an average operating load
on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
CF135A
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
7. Adjust each headlight by turning the adjuster knob
clockwise to raise the beam or counterclockwise to
lower the beam.
CF132A
ATV-0070C
CD714A
13