Arctic Cat 1000 XT 2014 Service Manual page 51

2. Install the second compression ring with the marking
"E TOP" directed toward the top of the piston.
3. Install the first (unmarked) compression ring; then
rotate the rings so the ring gaps are approximately
180° apart and oriented to the piston pin.
Incorrect installation of the piston rings will result in
engine damage.
CYLINDER /CYLINDER HEAD
ASSEMBLY

NOTE: If the cylinder/cylinder head cannot be trued,
they must be replaced as an assembly.
Cleaning/Inspecting Cylinder Head
GZ168
The cylinder head studs must be removed for this pro-
cedure.
1. Using a non-metallic carbon removal tool, remove any
carbon buildup from the combustion chamber being
careful not to nick, scrape, or damage the combustion
chamber or the sealing surface.
2. Inspect the spark plug hole for any damaged threads.
Repair damaged threads using a "heli-coil" insert.
3. Place the cylinder head on the surface plate covered
with #400 grit wet-or-dry sandpaper. Using light pres-
sure, move the cylinder head in a figure eight motion.
Inspect the sealing surface for any indication of high
spots. A high spot can be noted by a bright metallic
GZ169A
finish. Correct any high spots before assembly by con-
tinuing to move the cylinder head in a figure eight
motion until a uniform bright metallic finish is
attained.
Water or parts-cleaning solvent must be used in con-
junction with the wet-or-dry sandpaper or damage to
the sealing surface may result.
Measuring Cylinder Head Distortion
1. Remove any carbon buildup in the combustion cham-
ber.
2. Lay a straightedge across the cylinder head; then
using a feeler gauge, check the distortion between the
head and the straightedge.
GZ167
3. Maximum distortion must not exceed specifications.
Cleaning/Inspecting Cylinder
GZ187A
1. Wash the cylinder in parts-cleaning solvent.
CAUTION
CAUTION
CAUTION
CC141D
49