Arctic Cat 1000 XT 2014 Service Manual page 142

2. Press the piston into the caliper housing using hand
pressure only. Completely seat the piston; then wipe
off any excessive brake fluid.
3. Apply high-temperature silicone grease (supplied
with the O-ring kit) to the inside of the caliper holder
bores and O-rings; then install the four O-rings into
the caliper.
140
PR715
4. Install the caliper onto the caliper holder making sure
the caliper and holder are correctly oriented.

NOTE: It is very important to apply silicone grease
to the O-rings and caliper bores prior to assembly.
PR717A
5. Making sure brake fluid does not contact the brake
pads, compress the caliper holder toward the caliper
and install the inner brake pad; then install the outer
pad.
If brake pads become contaminated with brake fluid,
they must be thoroughly cleaned with brake cleaning
solvent or replaced with new pads. Failure to do so will
result in reduced braking and premature brake pad fail-
ure.
PR711A
PR712
CAUTION
PR719C
PR239C
PR238