Arctic Cat 1000 XT 2014 Service Manual page 20


NOTE: At this point, the cap screw in the fixed face
can be removed.
3. Rotate the V-belt and clutches until the V-belt is
flush with the top of the driven clutch.
18
4. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws mak-
ing sure the different-lengthed cap screws are in their
proper location. Tighten the cap screws to 8 ft-lb.
GZ485A
5. Install the
ing/Frame/Controls).
6. Secure the front fender to the footrest with the two
cap screws. Tighten securely.
right-side footrest (see
CD083
Steer-