Arctic Cat 1000 XT 2014 Service Manual page 84

6. From the opposite end of the countershaft, install the
high/low driven gear dog (A), thrust washer (B), bush-
ing (C), bearing (D), high/low driven gear (E), and
spacer washer (F).
7. Install the drive gear washer and the shift forks. The
countershaft is now ready for installation.
Assembling Crankcase
Half
1. Install the oil pump gerotor assembly and oil pump
cover in the crankcase and secure with two cap
screws. Coat the threads with red Loctite #271 and
tighten securely to 8 ft-lb.
2. Install a flat washer, drive pin, and drive gear onto the
oil pump shaft; then secure with a snap ring (flat-side
away from the gear).
82
GZ312
3. Install the countershaft into the crankcase and secure
with the snap ring (flat side away from the bearing).
4. Install the countershaft gear onto the countershaft and
GZ283B
secure with a snap ring (flat-side away from the gear).
5. Using rubber bands to support the connecting rods,
carefully install the crankshaft assembly into the
crankcase.
GZ305
GZ347
GZ463A
GZ299A