Arctic Cat 1000 XT 2014 Service Manual page 32

5. Adjust the handlebar direction until the two measure-
ments are equal; then secure the handlebar to the rear
rack using tie-down straps.

NOTE: Care must be taken not to allow the handle-
bar to turn while securing it.
6. Measure the distance from the inside of each front
rim to the lower frame tube.
30
DE047A

NOTE: The distances from the inside rims to the
frame tubes should be equal. If the measurements
are equal, proceed to step 8; if the measurements are
not equal, proceed to step 7.
7. To make the measurements equal, loosen the appro-
priate tie rod jam nuts and adjust accordingly; then
tighten the jam nuts and proceed to step 8.
CD014
AF785D

NOTE: The front wheels do not have to be removed
to adjust the tie rod. Also, care should be taken not to
disturb the handlebar position.
8. Using a permanent marker of some type, mark the
center of each front tire (at a height parallel to the
belly panel).
AF786D
AF617D
AF778D