Arctic Cat 1000 XT 2014 Service Manual page 71

2. Install the clutch shoe assembly and secure with the
flange nut (threads coated with red Loctite #271).
Tighten to 221 ft-lb.
3. Install the one-way clutch onto the clutch shoe
assembly.
CAUTION
Make sure the green dot (or the word OUTSIDE) is visi-
ble on the one-way clutch. Incorrect installation can
result in damage to the engine.
4. Place a new clutch housing seal (with the spring side
facing the clutch housing seal tool) into the clutch
cover and secure with a rubber mallet or press.
GZ240
5. Using a suitable press, install the bearing into the
clutch cover against the outer bearing face.
GZ241

NOTE: It is critical to verify the seal on the bearing
faces the clutch cover seal before pressing in the new
bearing.
6. Secure the bearing in the clutch cover using existing
bearing retainers and machine screws (threads coated
with blue Loctite #242). Tighten to 8 ft-lb.
GZ247B
7. Press the clutch housing assembly into the clutch
cover until it is seated against the bearing.
GZ503
GZ501
GZ508
69