Arctic Cat 1000 XT 2014 Service Manual page 115

1. Make sure the ignition switch is in the OFF posi-
tion; then remove the seat.
2. Locate the diagnostic plug next to the PDM; then
remove the black rubber cap.
3. Connect the Diagnostic Harness to the diagnostic
plug.
4. Turn the ignition switch to the ON position and
read the code on the LCD. Refer to the following
Code List to identify the specific problem area.
Code List

NOTE: Each of the following numerical codes will
have a two-letter prefix. A prefix of AC (Active Code)
or SC (Stored Code) will be displayed. Always correct
and clear Active Codes before clearing Stored Codes.
• 00 = No Fault Detected (active code only)
• 12 = CKP (Crankshaft Position) Sensor*
• 13 = MAP (Manifold Absolute Pressure) Sensor
• 14 = TPS (Throttle Position Sensor)
• 15 = ECT (Engine Coolant Temperature) Sensor
• 16 = Speed Sensor
• 21 = IAT (Inlet Air Temperature) Sensor
• 23 = Tilt Sensor*
• 24 = Ignition Coil #1*
• 26 = Ignition Coil #2*
• 32 = Fuel Injector #1*
• 34 = Fuel Injector #2*
• 40 = ISC (Idle Speed Control) Valve
• 41 = Fuel Pump Relay*
• 60 = Cooling Fan Relay
• 95 = Sensor Power
• 96 = Incorrect ECM*
• 97 = ECM Memory Power (constant battery power)
• 98 = ECM to Gauge Comm Link
• 99 = Start/Run Not Possible (active code only)
*Will initiate code 99.
After all active codes are cleared, clear stored code(s)
using the following procedure.

NOTE: The ignition switch should be in the OFF
position.
1. With the diagnostic harness connected to the diag-
ATV-112
nostic plug and the drive select switch in the 4WD
position, hold the reverse override switch down
and turn the ignition switch to the ON position.
2. After ten seconds, release the reverse override
switch and turn the ignition switch to the OFF posi-
tion; then turn the ignition switch to the ON position.
The display should read AC00 (no fault detected).

NOTE: If the LCD still displays a code, continue
troubleshooting the appropriate component.
3. Disconnect the diagnostic harness; then install the
black rubber cap.
4. Install the seat making sure it locks securely in
place.
113