Arctic Cat 1000 XT 2014 Service Manual page 139

2. Place an absorbent towel around the connection to
absorb brake fluid. Remove the banjo-fitting from
the master cylinder. Account for two crush washers
and a banjo-fitting bolt.
CAUTION
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the ATV.
3. Remove the snap ring and pivot pin securing the
brake lever to the master cylinder housing; then
remove the brake lever and set aside.
4. Dislodge the brakelight switch from the master cyl-
inder housing by gently pressing it toward the pivot
pin hole in the housing; then lay it aside leaving the
switch and wiring harness connected.
5. Remove the clamp screws securing the brake hous-
ing to the handlebar; then remove the assembly from
the handlebar.
AF637D
INSPECTING
1. Inspect the pin securing the brake lever for wear.
2. Inspect the brake lever for elongation of the pivot
hole.
3. Inspect the reservoir for cracks and leakage.
4. Inspect the banjo-fitting for cracks and deterioration
and the condition of the fittings (threaded and com-
pression).
5. Inspect the brakelight switch for corrosion, cracks,
missing or broken mounting tabs, or broken and
frayed wiring.

NOTE: If the brakelight switch is determined to be
not serviceable, see Electrical System.
DE059A
INSTALLING
1. Position the brake housing on the handlebar. Secure
with clamp screws; then tighten securely.
2. Using two new crush washers, connect the banjo-fit-
ting to the master cylinder; then secure with the
banjo-fitting bolt. Tighten to 20 ft-lb.
BC205
DE058A
DE058A
137