Arctic Cat 1000 XT 2014 Service Manual page 76

5. Remove the shift fork shaft (E); then remove the gear
shift shaft assembly (F). Account for a flat washer and
a spacer.
6. Remove two cap screws securing the oil pump in the
crankcase and remove the oil pump.
74
7. Remove the driveshaft (G); then remove the counter-
shaft assembly (with shift forks) (H). Account for two
flat washers on the countershaft.
GZ463B
8. Remove the reverse idler gear (I), shaft bushing, and
two washers.
DE677A

NOTE: Do not disassemble the countershaft assem-
bly unless necessary. If necessary, see Servicing
Center Crankcase Components sub-section.
Servicing Center
Crankcase Components
SECONDARY OUTPUT DRIVE GEARS
GZ276
Initial Set-Up

NOTE: If the secondary output driven shaft is
replaced or disassembled, the initial set-up must be
performed to establish correct gear tooth contact. If
only the secondary output driveshaft or secondary
output driven gear are replaced, proceed to Correct-
ing Backlash in this sub-section.
1. Install a new bearing (A) onto the secondary driven
shaft (B) making sure the bearing locating groove is
directed away from the driven gear splines.
GZ305
GZ280B
GZ279