Arctic Cat 1000 XT 2014 Service Manual page 19

3. Remove the nut securing the movable drive face;
then remove the face. Account for the flat washer
and spacer.

NOTE: Keep the drive face plate in contact with the
drive face when removing or installing the drive face
to prevent the rollers from falling out.
4. Install one of the CVT cover cap screws into the
driven pulley fixed face; then turn the cap screw
clockwise to spread the pulley faces. Remove the
V-belt.
CD078
INSTALLING
1. Place the V-belt into position on the driven pulley
and over the front shaft.
CD963

NOTE: The arrows on the V-belt should point in
CD966A
direction of engine rotation (forward).
2. Pinch the V-belt together near its center and slide the
spacer and movable drive face onto the driveshaft.
Secure the drive face with a washer and nut (coated
with red Loctite #271). Tighten the nut to 165 ft-lb.
Make sure the movable drive face plate is fully engaged
onto the splines of the clutch shaft before tightening the
nut or false torque readings may occur. This will cause
the assembly to loosen damaging the shaft and clutch
face plate.
CAUTION
GZ076
GZ085
GZ085
17