Arctic Cat 1000 XT 2014 Service Manual page 67

15. Using Seal Protector Tool, install the outer magneto
cover using a new gasket and secure with the cap
screws. Using the pattern shown, tighten to 112 in.-lb.
Right-Side Components

NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be
addressed and to service only those components. The
technician should use discretion and sound judgment.
AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.

NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. CVT Cover
B. Driven Clutch
C. Clutch Cover
D. Centrifugal Clutch
1. Remove the cap screws securing the CVT cover; then using
a rubber mallet, gently tap on the cover tabs to loosen the
GZ251
cover. Account for a gasket and two alignment pins.
2. Remove the nut securing the movable drive face; then
remove the face. Account for a spacer and a flat
washer.
GZ212B
3. Remove the V-belt.
4. Remove the nut securing the fixed driven assembly;
then remove the assembly.
GZ244B
GZ074
CD966A
65