Arctic Cat 1000 XT 2014 Service Manual page 31

4. Apply a small amount of grease to the hub splines.
5. Install the hub assembly onto the splines of the shaft.
6. Secure the hub assembly with the nut. Tighten only
until snug.
7. Secure the brake caliper to the knuckle with new
"patch-lock" cap screws. Tighten to 20 ft-lb.
AF618D
8. Pump the hand brake lever; then engage the brake
lever lock.
9. Secure the hub nut (from step 6) to the shaft. Using
an appropriate hub retaining wrench, tighten to 200
ft-lb.
10. Install a new cotter pin and spread the pin to secure
the nut.
11. Install the wheel; then using a crisscross pattern,
tighten to 40 ft-lb (steel wheels) or 80 ft-lb (alumi-
num wheels).
12. Remove the ATV from the support stand.
PR290A
Measuring/Adjusting
1. Thoroughly wash the ATV to remove excess weight
(mud, etc.).
2. Refer to the specifications and ensure the tires are
properly inflated to the recommended pressure.

NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not to
push down or lift up on the front end; then turn the
handlebar to the straight ahead position.

NOTE: When measuring and adjusting, there
should be a normal operating load on the ATV (with-
PR257
out an operator but with Arctic Cat approved acces-
sories).
4. Measure the distance from the outside edge of each
handlebar grip to equal reference points on each.
Toe-Out
PR264A
29