Arctic Cat 1000 XT 2014 Service Manual page 72

8. Install a new O-ring into a new fixed drive spacer,
then apply a thin coat of grease to the inner O-ring
and outside sealing surface of the drive spacer. Place
it over the clutch housing assembly.
9. Place the clutch cover/clutch housing assembly into
position on the crankcase; then secure with the cap
screws. Tighten in a crisscross pattern to 8 ft-lb.
10. Making sure the alignment pins are correctly installed,
place a bead of silicone sealant on the mating surfaces
and install the V-belt cover. Secure with new
"patch-lock" cap screws tightened to 8 ft-lb.
70
GZ512
11. Place the driven clutch assembly into position and
secure with the nut (coated with red Loctite #271).
Tighten to 165 ft-lb.
ATV2109
12. Slide the fixed drive face onto the clutch shaft.
13. Spread the faces of the driven clutch by threading in a
cap screw; then when the faces are separated, insert
the belt and push down between the faces.
GZ246B
GZ263B
GZ244A
GZ066