Incremental Fields Errors - Printronix ThermaLine Series Programmer's Reference Manual

Incremental Fields Errors

130 Not defined.
131 Incremental STEPMASK parameter error
A semicolon is missing after the STEPMASK data.
132 Incremental REPEAT/RESET parameter error
An illegal RPT or RST parameter value was found in the incremental
command. The value must range from 1 to 65,535.
133 Incremental STEPMASK/STARTDATA length error
The dynamic stepmask exceeded created field length or start data exceeded
stepmask.
134 Incremental EXECUTE command error
An illegal IRST or ICNT parameter value was found in the Execute
command. The value must range from 1 to 65,535.
135 Not defined.
136 Incremental STEPMASK/STARTDATA mismatched
The STARTDATA value must be A–Z or 0–9, when the STEPMASK value
is a value from 0–9.
137–139 Not defined.
140 PMODE or SMODE not the first command in the CREATE mode.
141 PMODE or SMODE syntax error.
142 PMODE or SMODE printer type PT parameter error.
143 PMODE or SMODE scaling parameter error.
144 PMODE or SMODE exit mode (EM) parameter error.
145 PMODE entries exceeded – maximum = 8.
146 Not defined.
147 Not defined.
148 Not defined.
149 Not defined.
8–22 Error Codes