Table of Contents
Advertisement
Option
Ext Execute Copy
Host Form Length
Power On IGP/PGL
Select SFCC
Uppercase
1–14
Parameter
Value
DISABLE*
If DISABLED, dynamic data, overlay data, etc. are not
allowed if the optional Form Count parameter is specified
ENABLE
as part of the Execute command.
If ENABLED, dynamic data, overlay data, etc. are allowed
within a form in which the Form Count parameter is
specified in the Execute command. In this case, the exact
same form (with identical dynamic data, etc.) is printed for
whatever the Form Count is. Also, each form is printed on
a separate page.
DISABLE
DISABLE sets the form length to the value set from the
front panel. ENABLE sets the printer page size equal to the
ENABLE*
form length defined in the CREATE FORM mode.
DISABLE
DISABLE puts printer in QUIET mode at power–up,
otherwise ENABLE or LISTEN mode is active at
ENABLE*
power–up.
1 – 255 decimal
Select any ASCII character from Table 1–5 on page 1–16
to set the binary pattern for the selected Special Function
126 *
Control Character. Default is decimal 126 (~).
DISABLE*
If ENABLED, all incoming data is converted to uppercase.
ENABLE
Comments
Introduction
Advertisement
Table of Contents
