Logo Call - Printronix ThermaLine Series Programmer's Reference Manual

Logo Call

Purpose Selects and positions previously defined logo(s). (The logo itself is actually
defined separately in the Create Logo mode.) The logo may be defined
using TIFF files, PCX raster data, or IGP/PGL dots.
Mode CREATE
Format LOGO
SR; SC; logoname
STOP
LOGO
SR
SC
logoname
STOP
4–72
The Logo Call command; enter LOGO.
Defines the starting row of the logo. The SR (and SC)
parameter specifies the location for the logo based on
the upper left corner of the grid in which the logo was
defined. Enter a value ranging from row 1 through one
less than the length of the form. Character row or dot
row is specified based on the Scale command (page
4–88), or use the CP.DP format (page 4–7).
Defines the starting column of the logo. The SC (and
SR) parameter specifies the location for the logo based
on the upper left corner of the grid in which the logo
was defined.
Enter a value ranging from column 1 through one less
than the width of the form. Character column or dot
column is specified based on the Scale command (page
4–88), or use the CP.DP format (page 4–7).
Identifies a previously defined logo by name for use on
the form. Enter the logo name exactly as used to define
and store the logo.
Stop indicates the end of the LOGO command; enter
STOP, and the IGP/PGL will wait for a new command.
If not entered, the IGP/PGL will expect another set of
Logo Call command parameters.
Commands