Table of Contents
Advertisement
Select Format
Purpose
Enables the IGP/PGL to ignore all host–generated paper movement
commands (00–0F hex).
Mode
NORMAL, CREATE or EXECUTE
Format
(cc)SFON or (cc)SFOFF
NOTE:
A line terminator is not required in the Select Format Sequence.
(cc)
SFON
SFOFF
Comments During Select Format, you may enter the following IGP/PGL paper
movement commands. All the commands must be entered in UPPERCASE.
These commands can only be used with the Select Format command. If
used at any other time, an error condition may result.
Command
(cc)CR
(cc)LF
(cc)FF
Although the Select Format command enables the IGP/PGL to ignore all
host–generated paper movement commands, you can input IGP/PGL paper
movement commands with Select Format on.
SFON/SFOFF cannot be used during Ignore Sequence (page 4–65).
Also, during the downloading of TIFF and PCX logos, the SFON/SFOFF
commands are ignored, and, instead, the printer receives the raw data.
4–90
The Special Function Control Character.
The Select Format On command. Enter SFON.
Exits Select Format. Enter SFOFF.
Paper Movement Function
Sends a carriage return (hex 0D)
Sends a line feed (hex 0A)
Sends a form feed (hex 0C)
Commands
Advertisement
Table of Contents
