Table of Contents
Advertisement
Logo Exercise
In this exercise, you will generate a logo. The following sample uses a hand
logo. Using dot scaling (discussed in detail on page 4–88) on an 8–1/2 x
11–inch form, a hand was drawn on a grid, with each dot tabulated by row
and column position. If a grid coordinate occupies half or more of a dot
position, include that position in your logo program. (Grid samples are
located in Appendix B.)
Each dot position used must be identified individually. However, you can use
a hyphen between the starting and ending columns to indicate a section of
consecutive dots. For example, this hand logo requires dots in row 1,
columns 40–42, shown in Figure 6–10. A sequential row order is not
required.
A logo is created and stored as an element in the definition of a form. For
example, to use a logo, first design it in the Create Logo mode; then add it to
a form in the Create Form mode; then execute the form (with the logo) in the
Execute Form mode. The following logo exercise includes all three of these
steps.
6–32
Form Examples and Exercises
Advertisement
Table of Contents
