Lines, Vertical - Printronix ThermaLine Series Programmer's Reference Manual

Lines, Vertical

Purpose Defines vertical lines.
Mode CREATE
Format VERT
LT; C; SR; ER
STOP
VERT
LT
C
SR
ER
STOP
Commands
The Vertical Line command; enter VERT.
Defines the line thickness, measured in 1/60" dots.
Enter a value of 1 or greater. Vertical line thickness
expands to the right from the starting column.
Defines the column where the vertical line begins.
Enter a value ranging from column 1 through one less
than the width of the form. Character column or dot
column is specified based on the Scale command (page
4–88), or use the CP.DP format (page 4–7).
Defines the starting row of the vertical line. Enter a
value ranging from row 1 through one less than the
length of the form. Character row or dot row is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
Defines the ending row of the vertical line. Enter a
value ranging from row 2 through the last column of
the form. The ending row must be greater than the
starting row. Character row or dot row is specified
based on the Scale command (page 4–88), or use the
CP.DP format (page 4–7).
Stop indicates the end of the VERT command; enter
STOP. If not entered, the IGP/PGL expects another set
of Vertical Line command parameters.
4–69