Printronix ThermaLine Series Programmer's Reference Manual page 24

Command
Compressed Print
Dynamic Alphanumeric
Data
Dynamic Bar Code Data
Expanded Print
Font
Ignore Sequence
On/Off
Incremental Alphanumeric
Dynamic Data
Incremental Bar Code
Dynamic Data
Line Spacing, Vertical
Multinational
Character Set
Normal Mode
Paper
Reset
Select Format
On/Off
1–12
Table 1–3. Execute Form Mode Commands
Mnemonic
DENSITY Defines the horizontal print density in characters per
inch (cpi).
AFn Executes the dynamic alphanumeric data provided
after the (cc) EXECUTE command.
BFn Executes the dynamic bar code data provided after the
(cc)EXECUTE command.
EXPAND Expands fonts vertically and horizontally.
FONT Selects a specific typeface, bold, slant (italic) factor,
and symbol set.
IGON Enables the IGP/PGL to ignore all characters after the
IGOFF Ignore Sequence On command is sent until the Ignore
Sequence Off command is sent.
See Note on Page 1–11.
IAFn Executes the incremental dynamic alphanumeric data
provided after the (cc) EXECUTE command.
IBFn Executes the incremental dynamic bar code data
provided after the (cc)EXECUTE command.
LPI Defines the lines per inch (lpi) printing format.
ISET Selects one of the 32 multinational character sets.
NORMAL Places the IGP/PGL in the Normal mode, where it does
not change the data stream but awaits the SFCC
followed by an IGP/PGL command.
PAPER Selects features such as paper cutter, print intensity,
label sensor, page orientation (portrait/landscape), and
print speed.
RESET Deletes all forms and logos from the IGP/PGL
memory.
SFON Ignores
SFOFF commands. See Note on Page 1–11.
Description
all host–generated paper
Page No.
4–33
4–54
4–55
4–60
4–61
4–65
4–57
4–57
4–66
Chapter 7
4–77
4–79
4–85
movement 4–90
Introduction