Printronix ThermaLine Series Programmer's Reference Manual page 20

Command Mnemonic
Compressed Print DENSITY
Configuration CONFIG
Create CREATE
Create Logo LOGO
Delete Form DELETE FORM
Delete Logo DELETE LOGO
Directory DIRECTORY
Execute EXECUTE
Expanded Print EXPAND
Font FONT
Ignore Sequence IGON
On/Off IGOFF
Line Spacing, LPI
Vertical
Listen LISTEN
Multinational USET
Character Set ISET
Normal Mode NORMAL
Paper PAPER
Print File PRINT
Quiet QUIET
Reset RESET
Select Format SFON
On/Off SFOFF
Set Up SETUP
Printer Mode PMODE
Scaling Mode SMODE
1–8
Table 1–1. Normal Mode Commands
Defines the horizontal print density in characters per inch (cpi).
Reconfigures IGP/PGL parameters.
Places the IGP/PGL in the Create Form mode where all the Create Form mode
commands are available to design form elements.
Places the IGP/PGL in the Create Logo mode, where logos can be defined using
the appropriate dot placements.
Deletes a selected form name from the directory and IGP/PGL memory.
Deletes a selected logo name from the directory and IGP/PGL memory.
Provides a list of all defined forms and logos, logo assignments to forms, and
memory usage and availability.
Executes a previously created form.
Expands fonts vertically and horizontally.
Selects a specific typeface, bold, slant (italic) factor, and symbol set.
Enables the IGP/PGL to ignore all characters after the Ignore Sequence On
command is sent until the Ignore Sequence Off command is sent. See Note on
Page 1–11.
Defines the lines per inch (lpi) printing format.
Removes IGP/PGL from the quiet state and enables IGP/PGL operation.
Use a multinational character set or create a custom user–defined character set.
Places the IGP/PGL in the Normal mode, where it does not change the data
stream but awaits the SFCC followed by an IGP/PGL command.
Selects features such as paper cutter, print intensity, label sensor, page
orientation (portrait/landscape), and print speed.
Prints a file from external memory
IGP/PGL operation is disabled until a Listen command is received. Any data
sent to the LinePrinter Plus Emulation is unaffected by IGP/PGL commands.
Deletes all forms and logos from the IGP/PGL memory.
Ignores all host–generated paper movement commands. See Note on Page
1–11.
Automatically executes and loads the IGP/PGL commands into the printer at
power–up or after a RESET command is sent.
Included only for compatibility; not recommended for use.
Included only for compatibility; not recommended for use.
Description Page #
4–33
4–34
4–39
4–74
4–41
4–42
4–43
4–49
4–60
4–61
4–65
4–66
4–71
Chapt. 6
4–77
4–79
4–83
4–84
4–85
4–90
3–2
N/A
N/A
Introduction