Copy Mode - ABB ACS355 series User Manual

84 Control panels
Step Action
4. Select the scalings for the signals by specifying the
minimum and maximum display values. This has no
effect if parameter
(DIRECT). For details, see parameters
3407.
Signal 1: parameters
OUTPUT1 MAX
Signal 2: parameters
OUTPUT2 MAX
Signal 3: parameters
OUTPUT3 MAX.


Copy mode

The basic control panel can store a full set of drive parameters and up to three user
sets of drive parameters to the control panel. Uploading and downloading can be
performed in local control. The control panel memory is non-volatile.
In the Copy mode, you can do the following:
• Copy all parameters from the drive to the control panel (uL – Upload). This
includes all defined user sets of parameters and internal (not adjustable by the
user) parameters such as those created by the ID run.
• Restore the full parameter set from the control panel to the drive (dL A –
Download all). This writes all parameters, including the internal non-user-
adjustable motor parameters, to the drive. It does not include the user sets of
parameters.
Note: Only use this function to restore a drive, or to transfer parameters to
systems that are identical to the original system.
• Copy a partial parameter set from the control panel to a drive (dL P – Download
partial). The partial set does not include user sets, internal motor parameters,
parameters 9905...9909, 1605, 1607, 5201, nor any group
MODULE and 53 EFB PROTOCOL
The source and target drives and their motor sizes do not need to be the same.
• Copy user set 1 parameters from the control panel to the drive (dL u1 – Download
user set 1). A user set includes group
internal motor parameters.
The function is only shown on the menu when user set 1 has been first saved
using parameter
and then uploaded to panel.
• Copy user set 2 parameters from the control panel to the drive (dL u2 – Download
user set 2). As dL u1 – Download user set 1 above.
• Copy user set 3 parameters from the control panel to the drive (dL u3 – Download
user set 2). As dL u1 – Download user set 1 above.
• Start, stop, change the direction and switch between local and remote control.
3404/3411/3418 is set to 9
3406 OUTPUT1 MIN
3413 OUTPUT2 MIN
3420 OUTPUT3 MIN
9902 APPLIC MACRO
LOC
3406 and
LOC
and 3407
and 3414
and 3421
parameters.
99 START-UP DATA
(see section User macros
Display
00
.
PAR SET FWD
5000
.
PAR SET FWD
51 EXT COMM
parameters and the
on page 119)
Hz
Hz