ABB ACS355 series User Manual page 214

214 Actual signals and parameters
All parameters
No. Name/Value
DI2
DI3
DI4
DI5
COMM
DI1(INV)
DI2(INV)
DI3(INV)
DI4(INV)
DI5(INV)
1609 START
ENABLE 2
1610 DISPLAY
ALARMS
NO
YES
Description
See selection DI1.
See selection DI1.
See selection DI1.
See selection DI1.
Fieldbus interface as the source for the inverted Start
enable (Start disable) signal, ie, Control word
WORD 2 bit 18 (bit 19 for Start enable 2). The Control word
is sent by the fieldbus controller through the fieldbus
adapter or embedded fieldbus (Modbus) to the drive. For
the Control word bits, see section
profile on page 333.
Note: This setting applies only for the DCU profile.
External signal required through inverted digital input DI1. 0
= Start enable. If Start enable signal is switched off, the
drive will not start or it coasts to stop if it is running and
alarm START ENABLE 1 MISSING
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
See selection DI1(INV).
Selects the source for the Start enable 2 signal. See
parameter 1608 START ENABLE
See parameter 1608 START ENABLE
Activates/deactivates alarms
OVERVOLTAGE (2002),
OVERTEMP (2009). For more information, see chapter
Fault tracing on page 349.
Alarms are inactive.
Alarms are active.
0302 FB CMD
DCU communication
(2021) is activated.
1.
1.
OVERCURRENT
PID SLEEP (2018) and
Def/FbEq
2
3
4
5
7
-1
-2
-3
-4
-5
NOT SEL
(2001), NO
DEVICE
0
1