Settings - ABB ACS355 series User Manual

170 Program features
Note: By default all Sequence programming parameters can be changed even when
the Sequence programming is active. It is recommended that after the Sequence
programming parameters are set, parameters are locked with parameter
PARAMETER LOCK.


Settings

Parameter
1001/1002
1102
1106
1201
1401
1402/1403/1410
1501
1601
1805
Group 19 TIMER & COUNTER
Group 32 SUPERVISION
2201...2207
Group 32 SUPERVISION
4010/4110/4210
Group 84 SEQUENCE PROG

Diagnostics
Actual signal
0167
0168
0169
0170
0171
Additional information
Start, stop and direction commands for EXT1/EXT2
EXT1/EXT2 selection
REF2 source
Constant speed deactivation. Constant speed always
overrides the Sequence programming reference.
Sequence programming output through RO 1
Sequence programming output through relay output
RO 2...4. With option MREL-01 only.
Sequence programming output through AO
Run enable activation/deactivation
Sequence programming output through DO
State change according to counter limit
Timed state change
Acceleration/deceleration and ramp time settings
Supervision settings
Sequence programming output as PID reference signal
Sequence programming settings
Additional information
Sequence programming status
Sequence programming active state
Current state time counter
Analog output PID reference control values
Executed sequence counter
1602