Quick Installation And Commissioning Flowchart - ABB ACS355 series User Manual

24 Introduction to the manual

Quick installation and commissioning flowchart

Identify the frame size of your drive: R0...R4.
Plan the installation: select the cables, etc.
Check the ambient conditions, ratings and
required cooling air flow.
Unpack and check the drive.
If the drive will be connected to an IT
(ungrounded) or corner-grounded system,
check that the internal EMC filter is not
connected.
Install the drive on a wall or in a cabinet.
Route the cables.
Check the insulation of the input cable and the
motor and the motor cable.
Connect the power cables.
Connect the control cables.
Check the installation.
Commission the drive.
Task
Operation principle and hardware
Type designation key
Technical data: Ratings
Planning the electrical installation
Technical data on page
Mechanical installation:
35
Operation principle and hardware
Type designation key
Electrical installation:
compatibility with IT (ungrounded) and corner-
grounded TN systems
Mechanical installation
Planning the electrical
cables on page 45
Electrical installation:
of the assembly on page
Electrical installation:
cables on page 51
Electrical installation:
cables on page 53
Installation checklist
Start-up, control with I/O and ID run
61
See
description:
on page 31
on page 374
on page
373
Unpacking on page
description:
on page 31
Checking the
on page 50
on page 33
installation: Routing the
Checking the insulation
49
Connecting the power
Connecting the control
on page 59
on page
39