ABB ACS355 series User Manual page 83

How to select the monitored signals
Step Action
1. You can select which signals are monitored in the
Output mode and how they are displayed with group
34 PANEL DISPLAY
detailed instructions on changing parameter values.
By default, the display shows three signals.
Signal 1: 0102 SPEED
Motor potentiometer, Hand/Auto and PID control;
0103 OUTPUT FREQ
Torque control
Signal 2: 0104 CURRENT
Signal 3: 0105
To change the default signals, select up to three
signals from group
shown.
Signal 1: Change the value of parameter
SIGNAL1 PARAM
parameter in group
(= number of the parameter without the leading
zero), eg, 105 means parameter
Value 100 means that no signal is displayed.
Repeat for signals 2
(3415 SIGNAL3
and 3415 = 0, browsing is disabled and only the
signal specified by
three parameters are set to 0, ie, no signals are
selected for monitoring, the panel displays text "n.A".
2. Specify the decimal point location, or use the decimal
point location and unit of the source signal (setting 9
[DIRECT]). Bar graphs are not available for basic
control panel. For details, see parameter 3404.
Signal 1: parameter
Signal 2: parameter
Signal 3: parameter
3. Select the units to be displayed for the signals. This
has no effect if parameter
(DIRECT). For details, see parameter 3405.
Signal 1: parameter
Signal 2: parameter
Signal 3: parameter
parameters. See page
for macros 3-wire, Alternate,
for macros ABB standard and
TORQUE.
01 OPERATING DATA
to the index of the signal
01 OPERATING DATA
0105
(3408 SIGNAL2
PARAM). For example, if
3408 appears in the display. If all
3404 OUTPUT1 DSP FORM
3411 OUTPUT2 DSP FORM
3418 OUTPUT3 DSP
3404/3411/3418
3405 OUTPUT1 UNIT
3412 OUTPUT2 UNIT
3419 OUTPUT3
LOC
82 for
LOC
LOC
to be
3401
TORQUE.
PARAM) and 3
3401 = 0
LOC
FORM.
LOC
is set to 9
UNIT.
Control panels 83
Display
103
PAR SET FWD
104
PAR SET FWD
105
PAR SET FWD
9
PAR SET FWD
3
PAR SET FWD