Parameters Mode - ABB ACS355 series User Manual

How to set the speed, frequency or torque reference
Step Action
1. If you are not in the Output mode, press
until you get there.
2. If the drive is in remote control (REM shown on the status
line), switch to local control by pressing
briefly shows a message about changing the mode and
then returns to the Output mode.
Note: With group
allow the reference modification in remote control.
3. • To increase the highlighted reference value shown in
the top right corner of the display, press
value changes immediately. It is stored in the drive
permanent memory and restored automatically after
power switch-off.
• To decrease the value, press
How to adjust the display contrast
Step Action
1. If you are not in the Output mode, press
until you get there.
2. • To increase the contrast, press keys
simultaneously.
• To decrease the contrast, press keys
simultaneously.


Parameters mode

In the Parameters mode, you can:
• view and change parameter values
• start, stop, change the direction and switch between local and remote control.
11 REFERENCE SELECT, you can
.
EXIT
repeatedly
REM
LOC
. The display
LOC
REM
LOC
. The
EXIT
repeatedly
LOC
MENU
and
LOC
MENU
and
Control panels 93
Display
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
DIR 00:00 MENU
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
00:00
DIR MENU
50.0Hz
50 0 Hz .
0 5 A .
10 7 % .
00:00
DIR MENU
Display
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
00:00
DIR MENU
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
DIR 00:00 MENU