ABB ACS355 series User Manual page 185

Actual signals
No. Name/Value
0144 DRIVE ON
TIME LO
0145 MOTOR TEMP Measured motor temperature. Unit depends on the sensor
0146 MECH ANGLE Calculated mechanical angle. 1 = 5001 PULSE NR. The
0147 MECH REVS
0148 Z PLS
DETECTED
0150 CB TEMP
0158 PID COMM
VALUE 1
0159 PID COMM
VALUE 2
0160 DI 1-5 STATUS Status of digital inputs.
0161 PULSE INPUT
FREQ
0162 RO STATUS
0163 TO STATUS
0164 TO
FREQUENCY
0165 TIMER VALUE Timer value of timed start/stop. See parameter group
0166 COUNTER
VALUE
Description
Drive control board power-on time in 2 second ticks (30
ticks = 60 seconds). Counter cannot be reset.
type selected by group
parameters.
signal indicates the angle as a percentage of the number of
pulses per revolution.
Mechanical revolutions, ie, the motor shaft revolutions
calculated by the encoder. Overflow is not prevented.
Encoder zero pulse detector. 0 = NOT DETECTED, 1 =
DETECTED.
Temperature of the drive control board in degrees Celsius
(0.0...150.0 °C).
Data received from fieldbus for PID control (PID1 and PID2) 1 = 1
Data received from fieldbus for PID control (PID1 and PID2) 1 = 1
Example (panel):
• 10000 = DI1 is on, DI2...DI5 are off.
• 10010 = DI1 and DI4 are on, DI2, DI3 and DI5 are off.
Example (DWL2):
• 16 (decimal) = DI1 is on, DI2...DI5 are off.
• 18 (decimal) = DI1 and DI4 are on, DI2, DI3 and DI5 are
off.
Value of frequency input in Hz
Status of relay output 1. 1 = RO is energized, 0 = RO is de-
energized.
Status of transistor output, when transistor output is used as
a digital output.
Transistor output frequency, when transistor output is used
as a frequency output.
TIMER & COUNTER.
Pulse counter value of counter start/stop. See parameter
group 19 TIMER & COUNTER.
Actual signals and parameters 185
35 MOTOR TEMP MEAS
FbEq
1 = 2 s
1 = 1
1 = 1
1 = 1
1 = 1
1 = 0.1 °C
1 = 1 Hz
1 = 1
1 = 1
1 = 1 Hz
19 1 = 0.01 s
1 = 1