Output Mode - ABB ACS355 series User Manual

92 Control panels


Output mode

In the Output mode, you can:
• monitor actual values of up to three signals in group
• change the direction of the motor rotation
• set the speed, frequency or torque reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the
display shows the reference
value. The center can be
configured to show up to three
signal values or bar graphs. If
just one or two signals are
selected for display, the number and name of each displayed signal are shown in
addition to the value or bar graph. See page
modifying the monitored signals.
How to change the direction of the motor rotation
Step Action
1. If you are not in the Output mode, press
until you get there.
2. If the drive is in remote control (REM shown on the status
line), switch to local control by pressing
briefly shows a message about changing the mode and
then returns to the Output mode.
3. To change the direction from forward (
status line) to reverse (
vice versa, press
Note: Parameter
(REQUEST).
EXIT
LOC
49 1 Hz
10 7 %
DIR
shown on the status line), or
DIR
.
1003 DIRECTION must be set to 3
01 OPERATING DATA
repeatedly.
49.1Hz LOC
.
0 5 A .
.
00:00 MENU
95 for instructions on selecting and
EXIT
repeatedly
REM
LOC
. The display
LOC
REM
shown on the
LOC
5.0Hz
Hz50%
0 4 A .
24 4 % .
DIR 00:00 MENU
Display
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
DIR 00:00 MENU
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
DIR 00:00 MENU
49.1Hz
49 1 Hz .
0 5 A .
10 7 % .
00:00
DIR MENU