Changing A Wheel - Seat Ateca Owner's Manual

● Screw the compressor tyre inflator into the
valve.
● Repeat the inflation process.
If the indicated pressure still cannot be
●
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
● Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
● When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
Check the pressure again after 10 minutes
●
›››

page 97.
›››

in TMS (Tyre Mobility System)* on
page 95

›››
page 95
64
The essentials

Changing a wheel

Vehicle tool kit
Fig. 70 Underneath the floor panel of the lug-
gage compartment: vehicle tool kit.
An adapter for the anti-theft wheel bolts*
1
Towline anchorage
2
Box spanner for wheel bolts*
3
Crank handle for jack
4
Jack*
5
Hook for extracting the central wheel
6
trims*
Clip for removing the wheel bolt caps.
7

›››
in What to do first on page 63

›››
page 95
Central wheel trim*
Correct positioning of the central
Fig. 71
wheel trim for steel rims.
The central trims must be removed for access
to the wheel bolts.
Removing
● Attach the wire hook (vehicle tools) to one
of the chambers of the central wheel trim.
● Insert the box spanner through the hook,
supporting it on the tyre and remove the
wheel trim.
Fitting
● Fit the central wheel trim onto the rim. The
bottom of the "S" of the SEAT badge should
›››
align with the inflation valve
Press the central trim firmly until it locks in
●
with an audible click.
Fig. 71 .
1