Seat Ateca Owner's Manual page 225

Vehicle ahead detected. ACC is active and
3
is regulating your speed.
Distance level 2 set by the driver.
4
ACC is active and is regulating your dis-
5
tance based on speed.
Warning and control lamps
›››
in Warning and control lamps on
page 119.
The speed reduction by the ACC to
 maintain the distance from the vehi-
cle in front is not sufficient.
Brake! apply the foot brake! Driver intervention prompt.

The ACC is not currently available.
With the vehicle stationary, switch off the engine and
start it up again. Check the SEAT badge area on the front
›››
Fig. 196 (in case it is dirty or icy or it has been hit). If
it is still unavailable, refer to a specialised workshop to
have the system inspected.
a)
The symbol on the instrument panels with colour display is in
colour.

The ACC is active.
No vehicle is detected in front. The programmed speed
remains constant.
Driver assistance systems
If the symbol is white: the ACC is ac-

tive.
A vehicle in front has been detected. The ACC adjusts
speed and distance from the vehicle in front.
If the symbol is grey: ACC is inactive

(Standby)
The system is switched on, but is not adjusting.
 It lights up green
The ACC is active.
Some warning and control lamps will light up
briefly when the ignition is switched on to
check certain functions. They will switch off
a)
after a few seconds.
WARNING
Observe the safety warnings
and control lamps on page
Note
When the ACC is connected, the indications
on the instrument panel screen may be con-
cealed by warnings from other functions,
such as an incoming call.
Radar sensor
Fig. 196
radar sensor.
On the front behind the SEAT badge, a radar
sensor has been installed to capture the traf-
fic situation
The radar sensor's visibility may be impaired
by dirt, mud or snow, or by environmental in-
›››
fluences such as rain or mist. In this case the
in Warning
119.
adaptive cruise control (ACC) does not work.
The instrument panel displays the following
message: ACC: No sensor vision! If
necessary, clean the SEAT badge area
When the radar sensor begins to operate
properly again, the ACC will automatically be
available again. The message on the instru-
ment panel screen will switch off and the ACC
will be reactivated again.
ACC operation may be affected by a strong ra-
dar reverse reflection. This may occur, for ex-
ample, in a closed car park or due to the
On the front behind the SEAT badge:
›››
Fig. 196.
›››
.
»
223