Lane Assist - Seat Ateca Owner's Manual

Please observe the indications on the in-
●
strument panel and act as is necessary.
● Always pay attention to the vehicle's sur-
roundings.
When the area of vision of the camera be-
●
comes dirty, covered or is damaged, the Lane
Assist system function can be affected.
CAUTION
In order to avoid influencing the operation of
the system, the following points must be tak-
en into account:
● Regularly clean the area of vision of the
camera and keep it in a clean state, without
snow or ice.
Do not cover the area of vision of the cam-
●
era.
● Check that the area of vision of the wind-
screen camera is not damaged.
Note
● The lane departure warning system has
been exclusively developed for driving on
paved roads only.
● If the Lane Assist system does not work as
described in this chapter, do not use it and
contact a specialised workshop.
● Before starting a journey, verify that the
field of vision of the camera is not covered
›››
Fig. 202.
Driver assistance systems
Always keep the field of vision of the cam-
●
era clean.
● If there is a fault in the system, have it
checked by a specialised workshop.
Traffic Jam Assist
Related video
Autonomous
Fig. 205
driving
Description and operation
Traffic Jam Assist helps the driver keep the
car within its lane and to move in convoy in
case of traffic congestion or slow traffic.
Traffic Jam Assist is an additional function of
›››
page 230

Lane Assist

and combines Lane
Assist functions with Adaptive Cruise Control
›››
page 221. Therefore, it is essential
(ACC)
that you read these two chapters carefully
and note the limitations of the systems and
the information about them.
Operation of Traffic Jam Assist
At speeds of below 60 km/h (40 mph), Traffic
Jam Assist can maintain a (temporary) dis-
tance preset by the driver with respect to the
vehicle ahead and help stay within the lane
›››
.
To do this, the system automatically controls
the accelerator, brakes and steering, and
slows the vehicle, stopping it fully if neces-
sary, when faced with a vehicle in front that
has stopped. It automatically moves off again
when the vehicle ahead moves.
Traffic Jam Assist is designed only for use on
motorways and wide roads. Therefore, never
use it in city traffic.
Technical requirements for using Traffic Jam
Assist
● Lane departure warning must be activated:
button > SETTINGS > Driver as-

sistance > Lane departure warning
›››

page
(Lane Assist)
● The Lane Centring Guide must be activated:
button > SETTINGS > Driver as-

sistance > Lane departure warning
(Lane Assist)
● Adaptive Cruise Control (ACC) must be con-
›››
page 224.
nected and active
● The speed must be below 60 km/h
(38 mph).
33.
»
233