Seat Ateca Owner's Manual page 99

CAUTION
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid over-
heating! Before switching on the air compres-
sor again, let it cool for several minutes.
Check after 10 minutes of driving
›››
Screw the inflator tube Fig. 97
and check the pressure on the gauge
1.3 bar (19 psi / 130 kPa) and lower:
Stop the vehicle! The tyre cannot be sealed
●
sufficiently with the tyre mobility set.
You should obtain professional assistance
●
›››
.
1.4 bar (20 psi / 140 kPa) and higher:
● Set the tyre pressure to the correct value
again.
● Carefully resume your journey until you
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
Have the damaged tyre replaced.
●
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious injury.
Do not continue driving if the tyre pressure
●
is 1.3 bar (19 psi / 130 kPa) and lower.
Seek specialist assistance.
●
Manual unlocking/locking
Introduction
Read the additional information carefully
›››

page 16,
again
5
.
6
The doors, rear lid and panoramic tilting sun-
roof can be locked manually and partially
opened, for example if the key or the central
locking is damaged.
WARNING
Opening and closing doors carelessly can
cause serious injury.
If the vehicle is locked from outside, the
●
doors and windows cannot be opened from
the inside.
● Never leave children or disabled people
alone in the car. They could be trapped in the
car in an emergency and will not be able to
get themselves to safety.
● Depending on the time of the year, temper-
atures inside a locked and closed vehicle can
be extremely high or extremely low resulting
in serious injuries and illness or even death,
particularly for young children.
Self-help
›››

page 17.
WARNING
Getting in the way of the doors and the rear
lid is dangerous and can lead to serious in-
jury.
● Open and close the doors and the rear lid
only when there is nobody in the way.
CAUTION
When opening and closing in an emergency,
carefully disassemble components and then
reassemble them carefully to avoid damage
to the vehicle.
Changing the windscreen wiper
blades
Changing the windscreen and rear
window wiper blades
Read the additional information carefully
›››

page 71.
The windscreen wiper blades are supplied as
standard with a layer of graphite. This layer is
responsible for ensuring that the wipe is si-
lent. If the graphite layer is damaged, the
noise of the water as it is wiped across the
windscreen will be louder.
Check the condition of the wiper blades regu-
larly. If the wipers scrape across the glass,
»
97