Seat Ateca Owner's Manual page 233

On the instrument panel display: In-
Fig. 204
dication on the Lane Assist system display
(example 2).
Status display
– The system is active, but not available,
either because the minimum speed has
not been reached or because the lane
›››
lines are not recognised
– The system is active and available, both
lane lines are recognised. The steering
angle is not being corrected at this mo-
›››
ment Fig. 203 B.
Driver assistance systems
– The system is operational, the highligh-
ted line
risk of involuntarily crossing the lane
line and that the steering is being adjus-
ted to correct the angle
– The two highlighted lines
multaneously when both lane lines are
recognised and the Lane Assist function
›››
is active
Control lamps
It lights up yellow: Lane Assist active

but not available.
The system can not accurately recognise the lane.
page
Please see
available (the control lamp is lit up yellow).

It lights up green
Lane Assist system active and available.
WARNING
Observe the safety warnings
and control lamps on page
Operating mode
Fig. 203 A.
Steering wheel vibration
The following situations can cause vibration
in the steering wheel and require the driver
to take active control of driving:
indicates that there was a
A
›››
Fig. 204 C.
light up si-
A
Fig. 204 D.
232, the Lane Assist system is not
›››
in Warning
119.
● When the steering angle assist value re-
quired to keep the vehicle in the lane is high-
er than the system's maximum operating val-
ue.
● If the system ceases to display the lane
lines while assisting with steering.
Switching the Lane Assist system on or off
Through the Easy Connect system
● Press the Easy Connect button
Press the function button
●
SETTINGS
● Press the function button
Driver assistance
open the menu.
OR: Using the Driving Assist button on
›››

the turn signal lever* page
Lane Assist with lane centring guide
The Lane Centring Guide function is in-
tended to keep the vehicle in the centre of
the lane.
If the driver has a tendency to veer slightly off
centre in the lane, the system adapts to driv-
er preferences.
The Lane Centring Guide function is ac-
tivated/deactivated in the Easy Connect sys-
tem using the button and the

›››
function button page 120.

to
37.
SETTINGS
»
231