Seat Ateca Owner's Manual page 218

Function
Switching the speed limiter on again
Increasing the set speed of the limiter
Reducing the set speed of the limiter
Switching off the speed limiter
The values shown in the table in brackets, in
mph, are displayed only in instrument panels
with indications in miles.
Going down slopes with the speed limiter
If the set speed of the speed limiter is excee-
ded while driving downhill, soon afterwards
the warning and control lamps flash 
216
Operation
›››
Position of the turn signal lever
›››
Fig. 189
Press button on the turn signal lever or move the third lever into posi-
3
tion .
Briefly press button on the turn signal lever in the  area or move
3
the third lever into position  to increase the speed in small incre-
ments of 1 km/h (1 mph) and set it.
Press  on the third lever to increase the speed in increments of
10 km/h (5 mph) and set it.
Hold down button on the turn signal lever in the area  or hold
3
down  to increase continuously in increments of 10 km/h (5 mph)
and set it.
Briefly press button on the turn signal lever in the  area or press
3
on the third lever to reduce the speed in small increments of 1 km/h
 1
(1 mph) and set it.
Press  on the third lever to reduce the speed in increments of
10 km/h (5 mph) and set it.
Hold down button on the turn signal lever in the  area or hold
3
down  to reduce the speed continuously in increments of 10 km/h
(5 mph) and set it.
Move control of the turn signal lever into position  or the third lever
1
into position .
›››
page 214 and an acoustic warning may
sound. In this case, use the foot brake to
slow the vehicle or, if necessary, select a low-
er gear.
Switching off temporarily
If you wish to temporarily switch off the
speed limiter, e.g. to overtake, move control
Fig. 188 or the third lever
Effect
The speed is limited to the set speed as soon as the speed
you are driving at is lower than the speed set as maximum.
The speed is limited to the set value
The speed is limited to the set value
The system switches off
›››
Fig. 188 of the turn signal lever into po-
1
sition  or the third lever into pressure
point  or press button
2
After overtaking, the speed limiter can be
switched on with the previously set speed by
pressing button on the turn signal lever in
3
the area  or by moving the third lever in-
to pressure point.
on any lever.